CHEMICAL TUBE RAMSET M30

CHEMICAL DESCRIPTION RAMSET M30 TUBE
Ramset M30 capsule chemical is a quick-setting chemical to attach M30x380 threaded rods to concrete to form M30x380 chemical bolts.

APPLICATIONS OF RAMSET M30x380 TUBE CHEMICAL
Structural steel anchors (e.g. racks, guard rails, fences and gates)
Anchoring in industries (e.g. machinery, elevators, cranes and industrial equipment)
Anchoring applications requiring dynamic loads or earthquake resistance
Securing items along the road and in the tunnel (e.g. impact and noise barriers, overhead catenary systems)
Anchoring at the edge of the slab or on narrow supports (e.g. beams, balconies)
ADVANTAGES OF RAMSET M30x380 TUBE CHEMICAL
Faster setting time than epoxy-based bottle chemicals using a pump gun (About 30 minutes compared to 8 hours)
Stable construction is easier than with epoxy-based bottled chemicals using a pump gun because a capsule is fixed to a threaded rod and there is no need to worry about pumping enough chemicals.
However, we must also mention the disadvantages that are more expensive and not as flexible as using pump-gun chemicals.
CHEMICAL CONSTRUCTION OPERATION FOR RAMSET M30x380 CUP TUBE
Step 1: Drill a 35mm hole, 300mm deep in the concrete
Step 2: Use a brush and dust blower to clean the bore
Step 3: place Ramset M30 capsule chemical into the drill hole
Step 4: Install the threaded rod into the drilling machine through a tool called the setting tool and then drill the threaded rod to break the sleeve
Step 5: Wait for the capsule chemical to set and then install the load. Normally, the setting time to reach maximum strength is 30-40 minutes
CHEMICAL FORCE SPECIFICATIONS RAMSET M30 TUBE TUBE USED WITH M30x380 THREADED ROD GRADE 5.8
Traction force: 150KN corresponding to a weight of 15 tons
Cutting force: 150KN corresponding to a weight of 15 tons
The above parameters are recommended when used with C20/25 basic concrete

CHEMICAL FORCE SPECIFICATIONS RAMSET M30 TUBE TUBE USED WITH M24x300 THREADED ROD GRADE 8.8
Traction force: 180KN corresponding to a weight of 18 tons
Cutting force: 180KN corresponding to a weight of 18 tons
The above parameters are recommended when used with C20/25 basic concrete