CHEMICAL BOLT TUBES M10

DESCRIPTION OF CHEMICAL BOLTS CUP M10:

M10 capsule chemical bolts are quick-setting chemical parts to attach M10x130 threaded rods to concrete to form M10x130 chemical bolts.

APPLICATION OF CHEMICAL BOLTS CUP M10

Structural steel anchors (e.g. racks, guard rails, fences and gates)
Anchoring in industries (e.g. machinery, elevators, cranes and industrial equipment)
Anchoring applications requiring dynamic loads or earthquake resistance
Securing items along the road and in the tunnel (e.g. impact and noise barriers, overhead catenary systems)
Anchoring at the edge of the slab or on narrow supports (e.g. beams, balconies)
 

ADVANTAGES OF CHEMICAL BOLTS M10 CUPBOARDS:

Faster setting time than epoxy-based bottle chemicals using a pump gun (About 30 minutes compared to 8 hours)
Stable construction is easier than with epoxy-based bottled chemicals using a pump gun because a capsule is fixed to a threaded rod and there is no need to worry about pumping enough chemicals.
However, we must also mention the disadvantages that are more expensive and not as flexible as using pump-gun chemicals.
 

CONSTRUCTION OPERATION FOR M10 CUP-UP CHEMICAL BOLTS:

Step 1: Drill a 12mm hole, 90mm deep in the concrete
Step 2: Use a brush and dust blower to clean the bore
Step 3: place the Ramset Maxima M10 capsule chemical into the drill hole
Step 4: Install the threaded rod into the drilling machine through a tool called the setting tool and then drill the threaded rod to break the sleeve
Step 5: Wait for the capsule chemical to set and then install the load. Normally, the setting time to reach maximum strength is 30-40 minutes
 

FORCE SPECIFICATIONS OF CHEMICAL BOLTS M10 TUBES USED WITH M10x130 THREADED ROD GRADE 5.8:

Traction force: 10KN corresponding to a weight of 1 ton
Cutting force: 10KN corresponding to 1 ton weight
The above parameters are recommended when used with C20/25 basic concrete

FORCE SPECIFICATIONS OF CHEMICAL BOLTS M10 TUBES USED WITH M10x130 THREADED ROD GRADE 8.8:

Traction force: 12KN corresponding to a weight of 1.2 tons
Cutting force: 12KN corresponding to a weight of 1.2 tons
The above parameters are recommended when used with C20/25 basic concrete